If you have used a stone engraving machine, you will find that sometimes when using this kind of machine, you will find that the knife and the machine tool cannot be controlled, as if it is disordered. In this case, what should I do? Many people think that the machine is in a difficult situation to repair, or that there is a problem in questioning the quality of the machine. In fact, it is not entirely the reason. If you find such a usage problem, follow the steps below.
First, stop the machine immediately. This is a must. Once the disorder is found, stop the machine and turn off the power. Because if it is confusing, it will destroy the engraving and typesetting of this time, and the subsequent engraving can no longer be carried out.
Then check the machine's knives and the gaps in the machine. When the stone engraving machine manufacturers are inspecting, they will find that many engraving machines are inaccurate or even confusing because they have stuck in the cracks or shafts, which makes the machine unable to operate normally. If this is the case, the stuck place is cleaned up, everything is restored to its original position, and there is no problem when it is used again.
If this is not the case, check if the screws in the area such as the shaft are loose, or if the connection between the engraving machine and the computer is loose. This is the case with the engraving machine. When these are excluded, if you still can't find the reason, you should call the manufacturer for repair.
