The advertising engraving machine has three axes, including the X axis, the Y axis, and the Z axis. The x-axis of the advertising engraving machine refers to the axis that moves left and right, the y-axis of the advertising engraving machine is the axis that moves forward and backward, and the z-axis of the advertising engraving machine is the axis that moves up and down. With these axes, the advertising engraving machine can move normally and freely, just like people's hands and feet. The guide rails of the advertising engraving machine also need to be cleaned frequently, which can make the advertising engraving machine work better. There are many brands of advertising engraving machines. The Dema brand is still good, you can consider it. Today we focus on the "advertising engraving machine xyz easy card machine".
Advertising engraving machine xyz easy card machine phenomenon?
The advertising engraving machine xyz easy card machine refers to the phenomenon that the device suddenly becomes stuck in a certain direction during the running process.
Why is the advertising engraving machine xyz easy card machine?
1. The advertising engraving machine works continuously for more than 24 hours. When the machine is in working state for a long time, the motor will heat up. If the heat reaches a certain level, it will return to the fault, and the motor torque will be insufficient to cause the card shaft phenomenon.
2. The motor parameters or pulse equivalent settings are incorrect. Sometimes you reinstall the system, and after installing the software, the parameters will be restored to the default values. Many parameters need to be modified.
3, processing speed or manual speed adjustment is too fast.
4. There are debris on the drive screw/rail.
What should I do with the advertising engraving machine xyz easy card machine?
1. Don't let the advertising engraving machine work continuously for 24 hours.
2. Set the motor parameters or pulse equivalents.
3, check the processing speed or manual speed, if it is too fast, then reset it.
4. Check if there are any sundries on the drive screw/rail, if any, clean it up.
Advertising engraving machine xy easy card machine misplaced?
Always misaligning to the right indicates that the X-axis is misaligned. If it is a rack machine, you need to check if the fit between the eccentric and the rack is loose. If the eccentric is normal, measure the diagonal again. If the angle is the same length, if the diagonal is not the same length, you need to remove the screws of the beam and adjust the beam. If the diagonal is normal, you need to remove the screws of the beam and adjust the beam if diagonal. If it is normal, replace the X-axis cable. In some cases, if the cable receives interference or the contact is not good, it will cause such misalignment.
Advertising engraving machine y easy slider stuck?
First use the air gun to blow off the ash on the side of the slider. If the woodworking machine should be a square slider, you can remove it. I said that the removal is not taken out. It is loosened and the slider is moved back and forth on the guide rail. Don't take it off the guide rails, it will drop the marbles. If you can't move, you can add some oil.
